Now we have finished and learned the techniques of making a SLOT, the second question comes up in the mind is “How to Mate with a SLOTâ€. Again there can be several ways to achieve this and one may adopt the method which he/she finds easy and quick to use. In this chapter let’s discuss about various simple ways of mating with a SLOT.
To use these methods you need a simple plate with a Slot of any size, a cylindrical, rectangular or square part with diameter/width equal to or less than slot width. In this chapter I’m going to use the cylindrical part (pin). I will be covering another discussion on same topic with a square part too.
Start you assembly with the plate inserted as the base part and fixed. You can also use mating techniques to position your plate. Now insert you pin which you want to mate with the slot.
Method 1: With your assembly opened and both the part inserted, select the back face of the plate and bottom face of the pin. Add a coincident mate between them. You can select front and top faces too. This is to set the initial position. Now show on the temporary axis (View > Temporary axis) to display the temporary axis of the pin. Select the side face of the plate and the temporary axis of the pin and give a distance mate. Repeat this with the bottom face. Your pin is now in to the required position.
Method 2: Using the same technique as described in method 1, use the planes instead of the temporary axis of pin to give distance mates with the side and bottom faces of the plate. Your planes may vary from the one shown in the picture.
The difference in the above two methods is that in Method 1 the part is not fully define and its free to revolve on its axis whereas in Method 2, the part gets fully defined.
Method 3: This is a combination of above 2 methods. Add a distance mate using the side face of the plate with the corresponding plane of the pin. Now show up the temporary axis if they are not on. Select either of the temporary axes of the slot and corresponding plane of the pin. Add a coincident mate.
Method 4: If your slot width and diameter of the pin and equal then you can use this method. Add a tangent mate between the side face of the slot and the cylindrical face of the second part. Then add a distance mate with the bottom/side face depending upon the location of your slot with the corresponding plane/temporary axis of the pin.
or
Method 5: In this method, RMB on the edge of the plate and select “Midpointâ€. Then select the corresponding plane of the pin and add a coincident mate. Then add a distance mate with the bottom/side face depending upon the location of your slot with the corresponding plane of the pin.
Method 6: This is tricky method and I prefer to use this method most of the time. Open the plate and edit the slot sketch. Add these two construction lines to your slot sketch. Now in assembly, select to show the slot sketch. Use the planes of the pin and mate them with the corresponding construction line
These are few of the methods which I use for mating with a slot. I would be interesting to hear if you more methods or any other method that you use for mating with the slot.